DIY Embossing CraftWork Shrink Wrap Tool 300W Handheld Mini Hot Air Gun Heat Gun

Description

Product Description
Description
This heat gun is not a High Power one due to its 300W low power. But it is great for heating shrinkable film, embossed powder, rubber stamp, the best choice to replace toaster or oven and the polymer clay will become hard and bright after using the gun.
Keeping 5-6cm distance from work and about a 45 degree angle to heat until it is completed.
After completion, use the heat gun at high temperature to blow a few seconds.
It not only can add its hardness, but also its brightness.
This kind of gun can not adjust the temperature but it heats up quickly at about 200℃ theoretically.
Therefore do not blow your Polymer Clay Works at one position for a long time to prevent distortion.
The hot air gun should not be used for a single time. If the temperature of the body is too high, please turn off the hot air blower and wait for the cooling to be used again.
Be careful when using the hot air gun.
Do not blow directly at a 90 degree angle
Specification
▪Color: White
▪Material: ABS
▪Type: Constant temperature
▪Rated power: 300W
▪Rated voltage: 110v
▪Working time: 5 minutes
SHIPPING POLICY - All orders are shipped in 1-2 days. Most orders go out same day.
RETURN POLICY - I offer a 30 day money back Guarantee. Contact me first if any problems should occur.
PICTURES & SPECS -
Please allow for some small indifference involving
specs, weights, colors, pictures,
and
measurements.